|
NO FIELD SWAGING
Pull-Lock™ fittings are designed for use with 1 × 19 L.H. lay strand only. They can be used with any tensioning device on the other end, but when used with our swageless tensioners, both ends can be put on the cable by hand without any swaging or special tools.
EASY TO INSTALL
You can order your cables with a tensioner already on one end or you can install a tensioner on one end on site. Attach the tensioner on one end post, slip the Pull-Lock™ fitting into the other end post and pull the cable all the way through the Pull-Lock™ fitting. Tension the cables, then cut the excess cable off on the back side of the fitting with a 4" right angle grinder or a cutting wheel that is used with your hand drill. Press on the stainless steel cap to cover the bare cable end, and you’re done!
|
Pull-Lock™ fittings are used with pipe and with round, square, or rectangular metal tubing. When used with an end post 1-1/2" or more in thickness, the Pull-Lock™ fitting is hidden inside the end post, with only the head exposed on the outside of the post. Pipe ends are counterbored so the full perimeter of the screw cap head rests on a flat surface in the pipe. The head rests on the outside wall of a flat-sided metal post. A Plastic Washer is included and acts as a scratch-resistant barrier between the screw cap head and the metal post. For wood applications, also order CR716SAE Stainless Steel Washer.
 |