

Mechanical Properties of Various Alloys
View Allowable Stress, Minimum Yield and Modulus of Elasticity for Aluminum, Bronze, Stainless Steel and Steel.
Material 
Allowable Stress (psi) 
Minimum Yield (psi) 
Modulus of Elasticity (psi) 
Aluminum, 6061T6 
21,000 
35,000 
10,000,000 
Aluminum, 6061T6 (pipe) 
24,000 
35,000 
10,000,000 
Aluminum, 6063T52 
9,500 
16,000 
10,000,000 
Aluminum, 6063T52 (pipe) 
11,500 
16,000 
10,000,000 
Aluminum, 6063T6 
15,000 
25,000 
10,000,000 
Aluminum, 6063T6 (pipe) 
18,000 
25,000 
10,000,000 
Bronze, Alloy C38500 
11,000 
19,000 
17,000,000 
Red Brass, Alloy C23000 (pipe) 
11,000 
18,000 
17,000,000 
Stainless Steel, Type 304 (tubing) 
30,000 
55,000 
28,000,000 
Carbon Steel, C1010 
20,000 
28,000 
29,000,000 
Calculations for Structural Design:
Basic Equation: When calculating bending stresses, the basis of reasoning is that the bending moment (M) applied to a post or rail must be equaled by the resisting moment. The latter is determined by the unit stress (f) of the railing material and the properties of the railing section  the section modulus (S).
M = f × S
Allowable Stress: The unit stress of a metal is determined by its composition and temper. In structural design, allowable design stress (fs), as used here, are based on a safety factor of 1.65, applied to minimum yield strength, which is generally accepted by the engineering profession. For aluminum round tube and pipe, the allowable stress is increased by a factor of 1.17.
Section Modulus, Neutral Axis: The section modulus (S) is determined by the size, shape and crosssectional area of a section. It may differ for each of the two neutral axes. The neutral axis of a symmetrical section is the center line. Otherwise, it is the line which passes through the center of gravity of the section, parallel either to its longest or shorted dimension. The two axes, x and y, are perpendicular to each other. For round and for square sections, the section modulus (S) is the same for either axis. Otherwise it is described as Sx or Sy, depending on which axis is involved. Moment of Inertia: The moment of Inertia (I) about the x or y axis is the section modulus (S) multiplied by c, the distance of the neutral axis or any section from the extreme fibre, that is from the farthest edge of the section, measured at right angles to the axis. 
Section Modulus Calculator 


